|
Fiat 640 2wd (75 hp) |
|
|
|
ENGINE POWER: At flywheel 75 HP/DIN
ENGINE: Fiat 8045.06
4 Stroke, 4 Cylinders
Bore and stroke: 100x115mm. Piston displacement: 3,613 cu.cm. Flyweight type dynamic balancer. Compression ratio: 17:1. Rpm at max. power: 2500.
Rpm
at max. torque: 1 400 Dry-type cylinder liners. Cooling system: water Four-row, steel tube and fin radiator. Force-feed lubrication system. Two power outlets for hydraulic. Pump on timing cover. Distributor-type injection pump with mechanical or hydraulic speed governor Five bearing crankshaft. 12 V starting system. 400 Watt alternator 110/120 Ah battery Gearbox mounted starter inhibitor switch.
OPERATING WEIGHT: 2,070 Kgs with 6.00-19 and 12.4/11-36 Tyres
STEERING Hydro Static Power with Dependent Circuit.
TURNING RADIUS: Minimum turning radius: With brakes : 3,400 mm Without brakes : 3,700 mm.
DRIVERS SEAT Fully upholstered, with parallelogram suspension; adjustable.
HYDRAULIC LIFT With draft and position control.Draft control through top link. Gear type pump driven from engine crankshaft. Pump capacity ( at 2,400 engine rpm): 24.8 liter/min Relief valve opening pressure:190 kg/sq.cm. Response control. 3-point linkage cat. 1-2. Sway chains and lower link retaining spring. Lift lever lock bracket. Max. lifting capacity: 1,650 kg.
TYRES Front: 7.50-16 Rear: 16.9/14-30
LIGHTING SYSTEM Three position headlights (parking low and high beam). Rear parking and number plate lights. Blue high beam warning light on instrument panel. (ASAE).
TRANSMISSION:
Gearbox with Constant-Mesh
SPEEDS (kph) with 12.4/11-36 tyres
FILTERS Air: oil bath with precleaner and automatic dust unloader; Fuel: 2 replaceable cartridges; Oil: easy to change, full-flow cartridge. Exhaust muffler: horizontal
FUEL TANK Capacity of fuel tank: 54 liters.
CLUTCH Dual plate, dry tape with separate controls. Plate facing of asbestos compound. Diameter of plates: 11 in.
BRAKES Service : dry band-type. Mechanically operated Parking: manual lever |
FRONT AXLE Inverted U section, telescopic type.
TREADS Front (8 positions): 1,320 1,420 1,520 1,620 1,720 1,820 1,920 2,020 mm Rear (8 positions): 1,320 1,420 1,520 1,620 1,720 1,820 1,920 2,020 mm
DIMENSIONS: (with 7.50-16 and 16.9/14-30 tyres)
POWER TAKE-OFF:
13/8 6 Spline Shaft * Depends on belt pulley
OPTIONALS
ENGINE Vertical exhaust muffler. Four row, copper tube and fin radiator Radiator screen. Cold starting aid (Thermostat). 132/140 Ah battery. Air cleaner with inlet on bonnet.
CLUTCH Gearbox with 11 plate and Ceramatallix buttons
TRANSMISSION Additional creeper speed reduction unit for a total of 12 forward and 3 reverse speeds. Bevel gear 14/47.
BRAKES Emergency: separate, transmission type.
DRIVERS SEAT Deluxe type with parallelogram suspension and hydraulic shock absorber; adjustable for reach and height.
POWER TAKE-OFF 540 rpm and proportional ground speed. Revolutions per approx. One meter forward travel (independently of gear engaged) 3:7.
HYDRAULICS External control valves (with single and double action rams), with quick coupling ½ female halves and implement remote control, supplied alone or with additional valve for trailer braking.
TYRES Front 6,00-16;7.50-16 Rear: 14.9/13-30;16.9/14-30;13.6/12-36.
TOWING ATTACHMENTS Front hook. Swinging drawbar. Cat. 1 linkage drawbar Trailer hitch of two types: standard or special (Rockinger)
LIGHTING SYSTEM Three types: 1) Two position headlights (low and high beam); front and rear direction and parking lights, number plate light. Seven pole power connector (DIN).
2) Same as type 1) plus front and rear emergency lights. Rear stop lights and direction warning light for second trailer.
3) Same as type 1) or 2) but with yellow bulb headlights. Rear flood light.
BALLAST Front axle (after deduction of 30 kg bracket guard) : 70 kg support supplier alone or together with 4- 6 plates of 30 kg each, for a total weight of 195 or 252 kg respectively Rear wheels: 4 or 6 discs of 58 kg each for a total weight of 235 or 350 kg respectively.
SAFETY FRAME With roof Conforms to OECD standards.
OPTIONAL EQUIPMENT:
- Front End Weights with Frame
- DTO Pulley
- Pintle/Trolley Hook (AGRIPAK
Design) - High Clearance Kit - Driver's Cabin
|
For details, please write us here |
www.agripak.com.pk @ 2005